Cue Editing; Delete A Cue; Store A Blackout Scene - iSolution IL-2420 Manuel D'utilisation

4.23 CUE Editing

1. Enter Program mode.
2. Press CUE button, use jog wheel #1 to select the page number.
3. Press the number button 1-20 ， to select the to be edited CUE number, at
this moment, all LEDs on CHASE are lit and all LEDs on the number button
which have saved CHASE will blink. Turn jog wheel #1 should change the
page number.
4. Press the number button to edit the Chase in CUE.
5. Press MANUAL/REC button, all LEDs blink for 3 times to indicate that
you have successfully edited a CUE.
6. Press PROGRAM button for 3 seconds to exit Program mode, the LED
goes out indicating this operation.

4.24 Delete a CUE

1. Enter Program mode.
2. Press and hold AUTO/DEL button.
3. Press CUE use jog wheel #1 to select the page number.
4. Then press the number button 1-20, all LEDs blink for 3 times to indicate
that you have successfully deleted a CUE.
86-
5. Press PROGRAM button for 3 seconds to exit Program mode, the LED
goes out indicating this operation.

4.25 Store a Blackout Scene.

Blackout Scene is a special scene of Blackout mode set in By Black Scene.
1. Enter Program mode.
2. Press the number button1-20 to select one or more fixtures.
3. Move FADERS1-24 to vary the channel outputs or use Jog wheel #1 、
#2 to adjust PAN and PAN FINE or use Jog wheel #3 , #4 to adjust TILT 、
TILT FINE.
4. Once the effect is adjusted, press MANUAL/REC button to store, at this
moment, all LEDs on
PRESET 、 C HASE 、 B ANK 、 B LACKOUT blink at the same time.
5. Press BLACK OUT/STAND ALONE button, all LEDs blink for 3 times to
indicate that you have successfully stored a Black Scene.
6. Press PROGRAM button for 3 seconds to exit Program mode, the LED
goes out indicating this operation.
CUE 、 OVERRIDE 、 CENTER 、 FIXTURE GROUP 、
87-