Program A Scene; Copy A Scene - iSolution IL-2420 Manuel D'utilisation

5. If it is necessary to adjust MOVEMENT parameter ， u se Jog wheel #2 to
select the adjusting MOVEMENT parameter options(position & range &
fade time or wait time & loop) ， u se Jog wheel #3 、 # 4 to adjust parameter
values.
6. Repeat Steps 2 – 5to select MOVEMENT for other FIXTURE.
7. Press MANUAL/REC to store into memory ， a ll the LEDs on CUE 、
OVERRIDE 、 C ENTER 、 F IXTURE GROUP 、 P RESET 、 C HASE 、 B ANK 、
BLACKOUT blink to indicate this operation.
8. Press BANK use Jog wheel #1 to select the BANK number to store the
scene.
9. Press the number button 1-20 to select the Scene number going to be
saved ， a ll LEDs and the Segment Display will blink for three times briefly
indicating this operation, then the LCD will show the bank and the scene
number of the programmed scene.
10. Repeat steps 2-9 to program other SCENEs with MOVEMENT
11. If you don't intend to continue your programming, press and hold down
the PROGRAM button for three seconds to exit Program mode, the LED
goes out indicating this selection.

4.4 Program a Scene

1. Enter Program mode.
2. Press the button BANK ， t o turn on its fader control, which is indicated by
the lit LED, use Jog wheel #1 to select the bank number to edit the scene.
3. Press the number button 1-20 to open the scene you are going to edit.
4. Move Faders 1-24 or use the
CENTER P RESET S CENE
、 、
68-
saved to change the output of each channel, you can also use the Jog wheel #1 、 # 2 to
adjust PAN 、 P AN FINE ， o r use Jog wheel #3 ， #4to adjust TILT 、 T ILT FINE or press
MOVEMENT to add MOVEMENT function.
5. Press MANUAL/REC to store ， L EDs on CUE 、 O VERRIDE 、 C ENTER 、
FIXTURE GROUP 、 P RESET 、 C HASE 、 B ANK 、 B LACKOUT blink at the
same time.
6. Press the button BANK.
7. Press the number button 1-20 to store the edited scene which will cover
the former scenes, all LEDs and the Segment Display will blink for three
times briefly indicating this operation, then the LCD will show the bank and
the scene number of the programmed scene.
8. Press the button PROGRAM for three second, to exit Program mode, the
LED goes out indicating this selection.
Hints: If you select different scenes at step 3 and 6, the editing scene would cover the
scene at step 6.

4.5 Copy a Scene

1. Enter Program mode.
2. Press the button BANK, to turn on its fader control, which is indicated by
the lit LED. ， u se Jog wheel #1 to select the bank number to edit the scene.
3. Press the number button 1-20 to open the scene you are going to copy.
4. Press MANUAL/REC to store ， L EDs on CUE 、 O VERRIDE 、 C ENTER 、
FIXTURE GROUP 、 P RESET 、 C HASE 、 B ANK 、 B LACKOUT blink at the
have
same time.
69-