Setting Menu; Create A New Fixture Profile - iSolution IL-2420 Manuel D'utilisation

5. Setting Menu

Entering the Menu
1. Enter Program mode.
2. Press ENTER/MAIN MENU Button ， t o enter LCD screen main menu.
Exiting from the Menu
Press ESC/CLEAR button to exit from the last menu until exit from the
Menu totally.
The main Menu including the following 17 settings:
1.

Create a new Fixture Profile

2. Modify a Fixture Profile
3. Delete a Fixture Profile
4. Patch a Fixture
5. Reverse channel setup
6. Fade mode setup
7. Blackout mode select
8. .Midi channel select
9. Chase run by inside/outside time
10. Auto remote address
11. Read cf card
12. Write cf card
13. Modify Password
14. Enable Password
15. Erase all memory
16. audio input range adjust
17. Channel value display mode
88-
You can select the Menu by Jog wheels and press ENTER/MAIN MENU to
enter sub Menus for editing.
5.1 Create a new Fixture Profile
1. Enter Menu Mode.
2. Turn jog wheel #1 up to when the 01.Create a new Fixture is shown on
the monitor, press ENTER/MAIN MENU Button to enter.
3. Use Jog wheel #2 and #4 to change the name of the FIXTURE. Turn Jog
wheel #2 to change the position of the cursor, and Jog wheel #4 should be
used to change the trait of the channel or character. The amount of the
letters must be below 26, it can be include ten numbers ， one "—", the length
of the Fixture name should be below 16, and it must be begin with letter.
4. Press ENTER/MAIN MENU button to change the trait of the channel.
5. Use Jog wheel #2 and #4 to change the trait. Turn Jog wheel #2 to
change the position of the cursor, and Jog wheel #4 to change the trait of
the channel or characters.
6. Press ENTER/MAIN MENU to enter
7. Use jog wheel #2 to select profile (ACME
LIBRARY) you want to store the fixture profile.
8. Press ENTER/MAIN MENU button, all LEDs blink for 3 times to indicate
that you have successfully edited a FIXTURE PROFILE.
LIBRARY or OTHER
89-