Camille Bauer Digem f 96x48CK Mode D'emploi page 145

P
Setting limit values
Attention: If the Loc message blinks at the beginning of limit value setting, the limit values are pro-
tected against change.
Each limit value is stored with P, and the preset value for the subsequent limit value is then displayed
in blinking fashion.
Saving Limit Values
The limit values can be protected against change in two ways.
!
Attention!
This work may only be carried out by a trained electrician. The pc board accessed during
this work is live.
• By bridging terminals 8 and 11 at the rear of the instrument (see chap. 3.5 page 7).
• With a coding switch in the instrument.
To this end remove the front frame, the front plate
and the front panel. Two coding switches are located
at the right of the display. In order to lock in the limit
values, push the lower switch to the left. The limit
values are thus protected against change.
4.2 Minimum Value Panel Meter
As a rule, the instrument always displays the minimum measurement value . Current and maxi-
mum measurement values are read as follows:
Display
Min. Measurement Value
Current Measurement Value
Max. Measurement Value
Delete Min. Measurement Value (re-enable) first press ⇓ and then press ⇑ and ⇓ simultaneously
GOSSEN-METRAWATT
P
P
P
⇑
Set values
or
with
only for adapter
with 4 relays
Key Sequence
9