Camille Bauer Digem f 96x48CK Mode D'emploi page 123

Notes and Warnings
This instrument has been shipped from the factory in proper condition for safe operation. In order to
maintain this condition and to assure safe operation, the user must observe all notes and warnings
included in these operating instructions. If damage to the instrument causes any doubt concerning
safe operation, it must be taken out of service. Visible damage always represents cause for such
doubt. Prior to initial start-up it must be determined, whether or not the measuring instrument is
equipped for the proposed application (correct supply voltage, inputs and outputs). The model of the
instrument and possible options are identified on the serial plate. When covers are opened or com-
ponents are removed, voltage conducting parts may be exposed. Balancing, maintenance or repair
of an open, live instrument may only be carried out by trained personnel who are familiar with the
dangers involved.
1 Applications
This measuring instrument is suited for applications in which the monitoring and evaluation of meas-
urement values are required, which, if applicable, must also be transmitted via analog outputs or a
serial interface.
2 Installation
First push the instrument into the switch panel without screw clips. The screw clips are then set into
the cone-head rivets at the side panels. The instrument can then be tightened to the switch panel
with the screws. For installation into a grid mounting system, the fastening elements designed espe-
cially for the grid system in use are set into the cone-head rivets . The complete instrument can then
be inserted into the grid system.
!
Attention!
If several devices are installed with maximum component density it must be observed,
that the allowable operating temperature of 50 ˚C is not exceeded despite specific heat.
Dimensional drawing with switch panel opening: 45
92
GOSSEN-METRAWATT
4
96
90.5
+0.6 +0.8
x 92 mm
3