Routine Cleaning; Periods Of Inactivity - Nordcap MORETTI P Serie Mode D'emploi

4.2

ROUTINE CLEANING

After carrying out the operations described in point 4.1 above, clean the
appliance as follows:
Every day, at the end of operations and after leaving the appliance to cool
down, carefully remove from all parts of the oven, any residues that might
have collected during cooking, using a damp sponge or cloth and a little
soapy water, if necessary. Rinse and dry the areas, being sure to wipe
parts with satin finish in the direction of the finish (Fig.22).
Carefully clean all accessible parts.
WARNING!
Every day, carefully clean off any fat or grease
that may have dripped during cooking as this is a potential fire
hazard.
WARNING!
Never clean the appliance with water jets or
steam cleaners. Do not allow water or any cleansers used to come into
contact with electrical parts.
The use of toxic or harmful detergents is prohibited.
NOTE:
Do not clean the tempered glass in doors while it is still
hot.
Do not use solvents, detergents containing aggressive substances
(chlorides, acids, corrosives, abrasives, etc. ...) or equipment that
could damage surfaces. Before starting up the appliance again, make
sure that none of the cleaning equipment has been left inside.
WARNING!
Under no circumstances clean the oven using
detergents that involve a health hazard.
WARNING!
When special cleaning operations requiring the
oven to be moved have to be carried out, the following operations
must be performed by specialised personnel: carry out the operations
indicated in point 4.1, disconnect the exhaust pipe, the gas and electric
power supply, remove the oven positioning brackets and release the
brakes on the front wheels, then commence cleaning operations; carry
out the above operations in reverse order to restore the machine to
normal operation.
WARNING!
Periodically (at least once a year), and every time
operating malfunctions occur, the appliance must be checked by a
specialist technician who must check the general state of the
appliance, and in particular the state of the burner. In the presence of
any type of irregularity the burner must be replaced immediately.
When any maintenance operations are carried out on the gas circuit,
use LOCTITE 577 as a sealing agent
4.3

PERIODS OF INACTIVITY

If the appliance is not to be used for long periods:
- Disconnect it from the power supply.
- Turn the gas supply off.
- Cover it to protect it from dust.
- Ventilate the rooms periodically.
- Clean the appliance before using it again.
- Run the heating procedure as for the first start (see 3.2.1).
UK/7