Manual Connection Of The Charge App - Mennekes AMTRON Xtra E Mode D'emploi

If a charging station was found, a menu for entering the
name and PIN 1 of the charging station is displayed.
Fig. 11: Entering PIN and name
4. Enter the PIN 1 associated with the displayed serial
number (see set-up data sheet) of the charging station
and change the suggested name as desired (maximum
22 characters).
5. Confirm the entry with "Save".
The successful set-up is confirmed with a dialogue box. If
another charging station has been detected, perform steps 3
and 4 again until all charging stations found have been set
up.
21

4.7.3 Manual connection of the Charge APP

Fig. 12: Message "no Wallbox detected"
In rare cases, charging stations will not be detected
automatically. You then have the option to repeat the search
or set up the charging stations manually.
The IP address of the charging station must be known for
manual set-up.