Network Connection With Mennekes Charge App - Mennekes AMTRON Xtra Guide D'installation

6.7.1 Network connection with MENNEKES Charge APP

There are the following options to establish a connection between the mobile device and the MENNEKES Charge APP
Operating
For some tasks it is necessary to enter a PIN. These can be found on the set-up data sheet. After entering an
incorrect PIN ten times, PIN input will be blocked for five minutes.
Through access point
The access point is always active if the device has not been integrated with WLAN in a home network or if no
WLAN network is available.
f Activate WLAN on the terminal.
f Search for available WLAN networks.
f Select the network of the desired device. The name consists of the product name and the MAC address of the device
(e.g. AMTRON_7C70BCxxx).
f Enter WLAN WPA2 key and connect to the network.
Integration in the home network
If the device and the terminal are integrated in the home network, no further configuration is necessary.
Î "6.3.2 Integrating into the home network"
Through access point
Integration in the home network
EN
29