Setting Up Network Connection - Mennekes AMTRON Xtra Guide D'installation

6.3.1 Setting up network connection

Setting up network
The network connection is established either as a direct connection with a LAN cable or as an access point via the WLAN
of the device.
Direct connection
In order to establish a direct connection via LAN, the device and the terminal device (PC / laptop)
must be in the same address area. The IP address of the device is static when the connection is
direct.
IP address: 192.168.0.100
f Connect the device and the terminal with a LAN cable.
f Change the properties of the network connection at the terminal:
IPv4 address: 192.168.0.21
IPv4 subnet mask: 255.255.255.0
f Open the Internet browser. The service interface can be reached at http://192.168.0.100:25000.
As access point
f Activate WLAN on the terminal.
f Connect the terminal to the WLAN network of the device.
To do this, enter the WLAN WPA2 key (setup data sheet).
f Open the Internet browser. The service interface can be reached at http://172.31.0.1:25000
or at http://myamtron.com:25000.
The access point is always active if the device has not been integrated with WLAN in a home network or if no
WLAN network is available.
18
connection
When delivered, the internal WLAN module operates as an access point. This means that the
device makes its own WLAN network available, with which the terminal (PC / laptop / tablet /
smartphone) can be connected.
IP address: 172.31.0.1
The WLAN of the device is secured with WPA2 encryption.
As direct con-
nection
As access point
LAN
Wi-Fi