Maintenance; Filter; Cleaning A Dry Filter; Cleaning A Wet Filter - Workshop WS0500WM0 Manuel Du Propriétaire

Filter

WARNING: Do not operate
without filter cage and float, as they
prevent liquid from entering the
impeller and damaging the motor.
For dry material pick-up, do not
operate without the filter in place to
reduce the risk of damage to the
motor.
NOTE: This filter is made of high quality
paper designed to stop very small
particles of dust. The filter can be used
for wet or dry pick up. Handle the filter
carefully when removing to clean or
installing it. Creases in the filter pleats
may occur from installation but creases
will not affect the performance of the
filter.

Cleaning A Dry Filter

NOTE: For best cleaning results due to
accumulated dust, clean the filter in an
open area. Cleaning SHOULD be done
outdoors and not in the living quarters.
1. Light cleaning of some dry debris from
the filter can be accomplished without
removing the filter from the Vac. Simply
slap your hand on top of the handle
while the Vac is turned off.
2. Remove filter from Vac. Gently tap the
filter against the inside wall of your dust
drum and the debris will loosen and
fall.
3. For thorough cleaning of a dry filter
with fine dust (no debris) you may run
water through it as described under
"Cleaning A Wet Filter" Section.

Cleaning A Wet Filter

After filter is removed, run water through
the filter from a hose or faucet. take care
that the water pressure is not too strong
to damage the filter. Allow filter to dry
before use or storage.

MAINTENANCE

Cleaning and Disinfecting the
Wet/Dry Vac
To keep your Wet/Dry Vac looking its
best, clean the outside with a cloth
dampened with warm water and mild
soap.
To clean the drum:
1. Dump debris out.
2. Wash drum thoroughly with warm water
3. Wipe out with dry cloth.
Before prolonged storage or as needed
(i.e.; waste water pick up) the drum
should be disinfected.
To disinfect the drum:
1. Pour 1 gallon of water and 1 teaspoon
2. Let solution stand for 20 minutes,
3. Empty drum after 20 minutes. Rinse
SAFETY and RELIABILITY, repairs
and adjustments should be
performed by Independent Service
Centers, always using WORKSHOP
replacement parts.
16
and mild soap.
chlorine bleach into the drum.
carefully swishing every few minutes,
making sure to wet all inside surfaces
of the drum.
with water until bleach smell is gone.
Allow drum to dry completely before
sealing the motor on the drum.
WARNING: To assure product