Choosing The Correct Filter - Workshop WS0500WM0 Manuel Du Propriétaire

Choosing the Correct Filter

WARNING: To reduce the risk of
damage to the Vacuum, do not run
motor with float in raised position.
A cartridge filter should be present,
and in the correct position during
all vacuuming operations to avoid
debris leaks and possible damage to
the vacuum motor.
There are a variety of Filters available
for WORKSHOP ®
The Filters you choose should depend
upon the task you are performing.
Not all available Filters are included with
each model, but they may be purchased
as needed from retailers carrying
WORKSHOP Wet/Dry vacuums or from
www.WORKSHOPvacs.com.
The available Filters include:
1. Pleated Paper Cartridge Filters
a. The available Pleated Paper
Cartridge Filters include catalog
numbers WS21200F (Everyday
Dirt), WS22200F (Fine Dust), and
WS23200F (HEPA Media).
b. Each of these Pleated Paper
Cartridge Filters are intended for
cleaning up dry debris, however,
a small amount of liquid can be
picked up without damaging the
Filter. When maintained properly,
small amounts of liquid will not
cause damage to the Filter. When
picking up larger amounts of liquid,
the Pleated Paper Cartridge Filter
will become saturated, misting may
appear in the vacuum's exhaust,
and the Filter may be damaged.
After using the Vac to pick up small
amounts of liquid, the Pleated
Paper Cartridge Filter must be dried
to avoid mildew and damage.
OPERATION (continued)
Wet/Dry vacuums.
c. If you are using your vacuum to
pick up very fine dust, it will be
necessary for you to empty the
drum and clean the Filter at more
frequent intervals to maintain peak
vacuum performance.
d. See "Filter Removal and
Installation" section for directions on
how to change the Pleated Paper
Cartridge Filter.
2. Wet Application Cartridge Filter
a. The available Wet Application
Cartridge Filter is catalog number
WS24200F.
b. This Wet Application Cartridge
Filter is intended for cleaning up
liquids and wet debris only. It is
NOT to be used for any dry debris.
c. To maintain Filter performance,
rinse thoroughly with water after
each use.
d. See "Filter Removal and
Installation" section for directions on
how to change the Wet Application
Cartridge Filter.
14