Maintenance; Filter Bag; Easy To Replace Filter Bag - Workshop WS0255VA Manuel D'utilisation

Filter Bag

WARNING:
!
To reduce the risk of injury from
accidental starting, unplug power
cord before changing or cleaning
filter bag.
Your Filter Bag should be cleaned often to
maintain peak Vac performance.
NOTE: The Filter Bag is made of high
quality material designed to stop small
particles such as sawdust. Handle the
Filter Bag carefully when removing to
clean or installing a New Filter Bag.
Do not tear the Filter Bag during removal
or installation if your intent is to reuse the
Filter Bag.

Easy to Replace Filter Bag

1. Remove the Retainer Band and Filter
Bag from the Filter Cage.
2. Place the Replacement Filter Bag on
the Filter Cage until the open end
touches the bottom of the Powerhead
Assembly.
3. Install the Retainer Band around the
Filter Bag, locating it over the Rib Tabs
on the Filter Cage.
SP7102 WS0255VA WORKSHOP.indb 12

MAINTENANCE

IMPORTANT: To avoid damage to the
Blower Wheel and Motor, always reinstall
the Filter Bag before using the Vac for dry
material pick-up.
Take the dirty Filter Bag to a disposal
container and gently brush away small dirt
particles that may be adhering to the Filter
Bag material.
IMPORTANT:
the Filter Bag for tears or small holes.
Do not use a Filter Bag with holes or tears
in it. Even a small hole can allow a lot of
dust to come out of your Vac. Replace it
immediately.
Filter Bag
Rib Tab
Retainer
Band
12
After cleaning, check
Powerhead
Assembly
7/10/19 10:57 AM