Service And Repairs - Hitachi NR 90AD Manuel D'instructions Et De Sécurité

English
4. Maintenance chart (See page 20)
5. Operator troubleshooting (See page 21)
6. Service parts list
A: Item No.
B: Code No.
C: No. Used
D: Remarks
CAUTION
● Repair, modification and inspection of
Hitachi Power Tools must be carried out
by a Hitachi Authorized Service Center.
This Parts List will be helpful if presented
with the tool to the Hitachi Authorized
Service Center when requesting repair or
other maintenance. In the operation and
maintenance of power tools, the safety
regulations and standards prescribed in
each country must be observed.
Maintenance chart
ACTION
Drain air line filter daily.
Keep lubricator filled.
Clean filter element — then Prevent clogging of filter
blow air through filter in
direction opposite to
normal flow.
Clean magazine and feeder Prevent a jam.
mechanism.
Keep push lever working
properly.
Lubricate the Nailer after
nailing.
Drain air compressor.
20
MODIFICATIONS

SERVICE AND REPAIRS

● Only service personnel trained by
● Use
All quality Nailers will eventually require
servicing or replacement of parts because of
wear from normal use.
NOTE:
Specifications are subject to change
without any obligation on the part of
HITACHI.
WHY
Prevent accumulation of
moisture and dirt.
Keep the Nailer
lubricated.
with dirt.
Promote operator safety and Blow clean daily.
efficient Nailer operation.
Extend the Nailer life.
Keep the Nailer operated
properly.
Hitachi Power Tools are constantly being
improved and modified to incorporate
the latest technological advancements.
Accordingly, some parts (i.e. code
numbers and/or design) may be
changed without prior notice.
WARNING
Hitachi, distributor or employer shall
repair the Nailer.
only parts
recommended by Hitachi for repair.
Open manual petcock.
Fill with Hitachi pneumatic
tool lubricant.
Follow manufacturer's
instructions.
Blow clean daily.
Supply 5 – 10 drops of
lubricant into the Nailer.
Open petcock on air
compressor tank.
supplied or
HOW