Maintenance And Inspection - Hitachi NR 90AD Manuel D'instructions Et De Sécurité

3 Stop turning the adjuster when a suitable
position is reached for a nailing test.
4 Connect the air hose.
ALWAYS WEAR EYE PROTECTOR.
Perform a nailing test.
NOTE:
The information contained in this Manual is designed to assist you in the safe
maintenance of the Nailer.
Some illustrations in this Manual may show details or attachments that differ
from those on your own Nailer.
MAINTENANCE AND
INSPECTION
Read section titled "SAFETY" (pages 4 – 7).
WARNING
● Disconnect air hose and remove all nails
from Nailer when:
1) doing maintenance and inspection;
and
2) clearing a jam.
1. Inspecting the magazine
1 DISCONNECT AIR HOSE.
2 Clean the magazine. Remove paper
chips or wooden chips which may have
accumulated in the magazine. Lubricate
it with Hitachi pneumatic tool lubricant.
Cloth
MAINTENANCE
1
Disconnect
air hose
5 DISCONNECT AIR HOSE FROM NAILER.
6 Choose a suitable position for the
adjuster.
CAUTION
● Check that the nail feeder slides smoothly
by pulling it with finger.
If not smooth, nails can be driven at an
irregular angle and hurt someone.
2. Storing
When not in use for an extended period,
apply a thin coat of the lubricant to the
steel parts to avoid rust.
Do not store the Nailer in a cold weather
environment.
Keep the Nailer in a warm area.
When not in use, the Nailer should be
stored in a warm and dry place.
Keep out of reach children.
3. WARNING LABEL
Change the WARNING LABEL if missing
or damaged.
A new WARNING LABEL is available
from a Hitachi authorized service center.
English
Warning Label
19