Cleaning And Care; Specifications - Gazzini 10035332 Instructions De Montage Et Mode D'emploi

itself, in the vehicle handbook or on the turn signal lens.
Example: A 7.5-ohm resistor simulates 19.2 watts, an 8.2-ohm
resistor simulates 17.6 watts and a 10-ohm resistor simulates
14.4 watts. The resistors are available partly prewired and can
therefore be installed particularly easily; an incorrect connection
is no longer possible.
The special flasher unit with the order no. 10033844 (operating
range of 1 to 30 W) for LED turn signals can only be used if the
vehicle is equipped with two turn signal indicator lights. If, on
the other hand, there is a common turn signal indicator light for
the right and left turn signal circuit, or a hazard warning flasher
system or an acoustic turn signal, malfunctions may occur – in
these cases, resistors should be used.
Please keep in mind that if electronic flasher relays are used, the
failure of a turn signal is no longer indicated by the indicator
light. Therefore, carry out a function check before every journey.

7 | CLEANING AND CARE

Use warm soapy water or a motorcycle cleaner and a soft cloth
for cleaning the turn signals. Do not use a harsh cleaner which
could corrode the aluminium and do not use a high-pressure
cleaner, as this can destroy seals and drive water into the turn
signal. Afterwards, use a wax-based product which will protect
the surfaces against the elements.

8 | SPECIFICATIONS

Order no.
10035329
10035331
10035328
10035332
10035327
20
Threads Voltage/
M8 x 1,25 12V/2,7W
M8 x 1,25 12V/9,9W
M8 x 1,25 12V/9,9W
M8 x 1,25 12V/1,3W
M8 x 1,25 12V/1,4W
Height
wattage
14 mm
18 mm
15 mm
12 mm
12 mm
Width Depth
20 mm 14 mm
48 mm 18 mm
62 mm 16 mm
83 mm 21 mm
69 mm 28 mm