Assembly; Preparation; Attaching; Installing Directly On The Handlebar - Gazzini 10039622 Mode D'emploi

4 | Assembly

4.1 | Preparation

The gazzini Mirror can be installed at the end of the handlebar in two ways:
1
externally at the end of the handlebar tube
1
using special bar end inserts (sold separately) which are inserted into the
2
handlebar tube and either screwed on or clamped in place. gazzini Bar Ends are
sold separately and available in various designs.
The vehicle fi rst has to be jacked up stably and the existing mirrors and, if applicable,
the bar ends have to be removed. You then have to check whether the grips and the
switch units/controls on the handlebar can be pushed inwards by the width of the
mirror clamp so that the mirror can be attached externally at the end of the handlebar
tube (only possible if the switch units are not secured to the handlebar with pins).

4.2 | Attaching

4.2.1 | Installing directly on the handlebar

If this is possible, fi t the mirror with the appropriate adapter ring for the given
handlebar tube, connect it to the handlebar and check whether you still have free
access to the tank, the fairing and other vehicle parts in the desired installation
position, even when the steering is at full lock. Do not tighten the clamp until you have
done so, and then align the mirror at the head and at the mirror stem, whilst sitting on
the motorcycle, so that you have a good view of the traffi c behind you.
16
2

4.2.2 | Installation with a bar end

If the mirror cannot be fi tted to the outside of the handlebar tube, a suitable bar end
(sold separately) must be inserted into the handlebar. The mirror is then fastened to
the bar end. If the inside of the handlebar is freely accessible and hollow, an insert
with metal clamping sleeves can also be used. If an internal thread is available,
an insert with the appropriate thread and connection to the handlebar must be
used. Inserts with rubber bushings must not under any circumstances be used for
installation of the mirror. It would twist as a result of the weight of the mirror and the
airstream.
It is also imperative that you make sure that the mirror stem and the mirror clamp do
not press against the throttle twistgrip on the right-hand side of the handlebar. It must
continue to move freely and spring back by itself when released. After completing
installation, it is imperative that you check whether the throttle twistgrip moves freely
and the mirror does not collide anywhere even when the steering is at full lock.

5 | Storage

Until you're ready to install the gazzini Mirror, keep it in its original packaging and store
in a place that is protected from weather and moisture.

6 | Cleaning and care

Use warm soapy water or motorcycle cleaner and a soft cloth to clean the gazzini
Mirror. Never use any sort of cleaner that may corrode aluminium. Finally, apply
polishing wax to seal the surface of the mirror and protect it against the weather.
Take care not to get any wax on the mirror lens.

7 | Warranty

This product comes with the statutory two-year warranty. The warranty period begins
on the date of purchase. It does not cover normal wear and tear, use for anything
other than the intended purpose, or damage caused by an accident, tampering or
attempted repairs by unauthorised persons or customer service departments.

8 | Disposal

Dispose of packaging material and the product itself in accordance
with applicable local regulations.
17