Example:
Original brake light:
Original brake light gazzini LED Tail Light:
Watt difference:
Square of the electrical system voltage divided by the watt difference = required
resistor
²
12
= 7.57
19
A 7.5 ohm resister is required. (not included)
The resistor must then be connected in parallel.
You can find the original wattage by looking at the original bulb itself
or by checking in the workshop manual. It may also be indicated on the
lens of your tail light.
5 | Specifications
Dia. x D: 68 mm x 41 mm
12 V/ 0,8 W tail light, 2,8 W brake light, 0,8 W license plate light,
Two M5 bolts for mounting
Cable length: 300 mm
6 | Storage
If you are not installing your gazzini LED Tail Light immediately, you should store
it in a place where it is protected from the weather and moisture. The humidity
should not exceed 80%.
7 | Cleaning and care
Use warm soapy water or a mild motorcycle cleaner that is suitable for
aluminium and a soft cloth. Do not use a pressure washer, as it may damage the
seals, and water may get into your gazzini LED Tail Light. Afterwards, use a wax-
based care product which will protect the surface against the elements. Do not
apply the care product to the lens.
21 W
2,8 W
18,2 W
17