Warnings; Safety Instructions - Gazzini 10035332 Instructions De Montage Et Mode D'emploi

3 | WARNINGS

To ensure the safety of the vehicle, the turn signal must be
securely and firmly fixed – if turn signals fall off, they could
cause a road accident. You should observe the legal notices
regarding the installation of turn signals.

4 | SAFETY INSTRUCTIONS

 The warranty will be rendered null and void in case of any
damage caused by failure to follow these instructions for use.
We assume no liability for consequential loss or damage.
 We assume no liability in case of material damage or
personal injury caused by improper handling or failure to
follow the safety instructions. In such cases, the warranty will
be rendered null and void.
 For reasons of both safety and official approval,
unauthorised modification and/or changes to the product
are not permitted.
 Since these turn signals are universal products and are
not intended for only one particular vehicle, it is important
to make sure that the turn signals are suitable for your
motorcycle before you use them for the first time. In doing
so, always follow the instructions in your vehicle owner's
manual and the directions of the vehicle manufacturer. This
is essential, as improper use of this product or its unsuitability
for a vehicle could impair the safety of the vehicle and/or
damage it.
 Ensure that the turn signal is securely mounted and working
correctly before every journey.
 Ensure that commissioning is performed properly. In doing
so, follow these installation instructions.
 It is forbidden to install the turn signal in front of the exhaust
port or in the hot exhaust gas stream area.
 Make sure that the lighting device may not under any
circumstances be covered due to changes in dimensions, or
by accessories or luggage on the vehicle.
 Before carrying out any work on the vehicle's electrical
system, be sure to disconnect the vehicle battery – there is a
danger of short-circuit!
 When carrying out assembly work, ensure that the vehicle is
in a safe position and that the workplace is well lit.
 The turn signal should be mounted such that it is protected
15