Fuse Replacement - Monacor DMT-3050 Mode D'emploi

2) Remove the test tips from the circuit to be
tested.
3) Remove the screw at the rear panel of the
multimeter and take the panel off.
4) Insert the batteries while watching the po-
larity indicated into the battery compart-
ments.
5) Remount and screw again the rear panel.
7

Fuse Replacement

The multimeter is fused with a fuse F 0.5 A
quick-acting. In case of defective fuse the
multimeter must be opened to insert a new
fuse of the same type. To open the multimeter,
see chapter 6 "Battery Replacement".
8 Specifications
Measuring ranges/accuracy
DC voltage: . . . . . . . 300 mV/
AC voltage: . . . . . . . 3/30/300/450 V,
DC current: . . . . . . . . 300/3000 µA/
AC current: . . . . . . . . 300/3000 µA/
Resistance: . . . . . . . 300 Ω/
3/30/300/450 V,
±1.3 %
±2.3 %, 50/60 Hz
30/300 mA, ±2 %
30/300 mA, ±2.5 %,
50/60 Hz
3/30/300 kΩ, ±2 %
3 MΩ, ±6 %, 30 MΩ,
±10 %
GB
21