Operating And Functional Ele- Ments; Before Startup; Start Up; Operation - Kärcher KM 80 W G Mode D'emploi

Operating and Functional El-
ements
1 Push handle
2 Parking brake
3 Drive wheels
4 Roller brush
5 Application points for upgrade kids
6 Protective cover roller brush
7 Height adjustment roller brush
8 Petrol engine
9 Swivel bracket for angle adjustment of
the roller brush
10 Clutch lever travel drive
11 Gas lever
12 Clutch lever roller brush drive
Gas lever
2
1
1 Position "CHOKE"
Position of the gas lever for starting the
motor
2 Operating position "full load"
The appliance works best while in the
operating position.
3 "OFF" position
Motor off
Parking brake
1
1 Activate parking brake
2 Parking brake released
To unload the machine, proceed as follows:
 Remove the cardboard.
 Manually lift appliance off the pallet.
Kerb weight: approximately 70 kg
or
Fold up and install the push handle.
Then use the push handle to pull the
appliance off the pallet.
Fold up and install the push handle
 Loosen the star handle screw.
 Align the pushing handle.
 Tighten star handle screw.
Danger
Risk of explosion!
Only fuel up while motor is turned off.
–
Only use the fuels specified in the Op-
–
erations Manual.
Do not refuel the machine in enclosed
–
spaces.
Smoking and naked flames are strictly
–
prohibited.
Ensure that no fuel reaches the hot
–
open surfaces.
3
1 Filling nozzle
2 Tank lid
 Switch off engine.
 Open fuel filler cap.
 Use "regular unleaded petrol".
Tank filling with empty tank approx. 0.7
litre.
 Wipe off any spilt fuel and close fuel fill-
er cap.
Prior to start/safety test
Maintenance Works
 Check engine oil level.
 Check air filter.
 Check tyre pressure.
 Check the roller brush for wear and
2
wrapped belts.
 Check the height adjustment of the roll-
er brush.
 Check for smooth running of the
Bowden cables and the moveable parts
 Empty waste container (option).

Before Startup

Unloading

Start up

Refuelling
3
-
EN
 Check the fuel filler cap and other clo-
sures and replace if damaged.
 Check the sound absorber and replace
if necessary.
Note: For description, see section on Care
and maintenance.

Operation

Starting the machine
 Activate immobilising brake.
 Open fuel cock.
Turn the rotating knob parallel to the
hose of the fuel tap.
 Gas lever in " CHOKE" position.
 Pull the starter rope slowly until a resist-
ance can be felt.
 Pull starter rope swiftly.
 Once the motor runs, release the starter
rope. In order to work, put gas lever in
the "full load" position.
Sweeping mode
Danger
Risk of injury! During work, the roller brush
can eject stones or loose chippings to-
wards the front or sides. Make sure that this
does not endanger persons, animals or ob-
jects.
Caution
Do not sweep up packing strips, wire or
similar objects as this may damage the
sweeping mechanism.
Height adjustment roller brush
The height of the roller brush is adjusted via
a rotary knob. The height must be selected
so that the bristles just touch the ground.
Note: An adjustment that is too low leads to
overstraining the drives and unnecessary
wear of the roller brush without achieving a
better sweeping result.
 Turning in (–) direction: Roller brush ris-
es.
 Turning in (+) direction: Roller brush is
lowered.
11