Whirlpool W10726970 Instructions D'installation page 6

Nameplate Burner Ratings (Sea Level)
Natural Gas (Btu/hour)
19,000/17,000 BTU
17,000 BTU
15,000 BTU
9,200 BTU
8,000 BTU
5,000 BTU
NOTE: Refer to the model/serial/rating plate located on the oven
frame behind the top right side of the oven door for proper sizing of
spuds for each burner location.
5. Save the replaced orifice spuds in a plastic bag or other
container.
6. Replace the burner base using both screws.
7. Replace burner cap.
8. Repeat steps 1 through 7 for the remaining burners.
NOTE: For dual fuel models, go to the "Complete Installation"
section.
To Convert Oven Bake Burner
1. Remove the oven racks and the oven door.
2. Remove 2 screws and washers at the rear of the oven bottom.
3. Lift the rear of the oven bottom up and back until the front of
the panel is away from the front frame. Remove from oven and
set it aside on a covered surface.
A
A. Screws
B. Oven bottom
4. Remove 2 screws from the bake burner.
5. Slide the front of the bake burner to the side to remove tab from
front of oven. Lift the back of the bake burner off the oven
orifice, and set the bake burner aside. Do not disconnect the
wire.
A. Bake burner
B. Screws
6
LP Gas Orifice Spud Chart for Surface Burner
Burner Name LP (Btu/hour)
Stacked 15,000 BTU
Ultra-Rapid 14,200 BTU
Ultra-Rapid 14,200 BTU
Semi-Rapid 8,000 BTU
Semi-Rapid 8,000 BTU
Auxi 5,000 BTU
B
A
B
Replacement Orifice - LP gas (High Altitude)
Color Code
No color - main
Black/Orange - simmer
White/Orange
White/Orange
Red/Yellow
Red/Yellow
Red/Gray
6. Apply masking tape to the end of a 10 mm nut driver or
combination wrench to help hold the gas orifice spud in the nut
driver while changing it. Press nut driver down onto the gas
orifice spud and remove by turning the bake burner orifice
spud counterclockwise to remove.
Make sure to put this spud aside or mark the original spud to
distinguish between the replacement spuds.
Refer to the "Natural Gas Orifice Spud Chart for Bake and Broil
Burners" for the gas to be used after the conversion.
7. Replace the spud with the replacement bake burner spud.
Refer to the nameplate on the range located on the oven frame
behind the top right side of the oven door. Identify the bake
burner rating for this range from the nameplate.
8. Install the replacement gas bake burner orifice spud, turning it
clockwise until snug.
IMPORTANT: Do not overtighten.
Size Burner Location
0.96 mm
Left front
0.32 mm
1.00 mm Left front
1.00 mm Right front
0.75 mm Right rear
0.75 mm Center
0.60 mm Left rear
A
A. Oven orifice
A. Orifice spud
A