Whirlpool W10726970 Instructions D'installation page 5

4. Flip the blue regulator cap over and screw it back into the
metal cover.
A
A. Natural gas position
B. LP gas position
5. Screw the metal cover securely back into place. Do not
overtighten.
To Convert Surface Burners
1. Remove burner cap.
2. Lift the flame spreader from the burner holder.
3. Apply masking tape to the end of a 7 mm nut driver to help hold
the gas orifice spud in the nut driver while changing it. Press
nut driver down onto the gas orifice spud and remove by
turning it counterclockwise and lifting out. Set gas orifice spud
aside.
A
B
A. Orifice spud
B. Orifice spud holder
Nameplate Burner Ratings (Sea Level)
Natural Gas (Btu/hour)
19,000/17,000 BTU
17,000 BTU
15,000BTU
9,200 BTU
8,000 BTU
5,000 BTU
*Same orifices as shipped from factory for Natural gas.
B
C
D
C. Screw
D. Spark electrode
Natural Gas Orifice Spud Chart for Surface Burners
Burner Name LP (Btu/hour)
Stacked 15,000 BTU
Ultra-Rapid 14,200 BTU
Ultra-Rapid 14,200 BTU
Semi-Rapid 8,000 BTU
Semi-Rapid 8,000 BTU
Auxi 5,000 BTU
4. Locate the model/serial/rating plate on the range. It will be
located on the oven frame behind the top right side of the oven
door. Identify the burner ratings for this range from the
nameplate.
Refer to the "Natural Gas Orifice Spud Chart for Surface Burners"
or the "LP Gas Orifice Spud Chart for Surface Burners" for the gas
to be used after the conversion. Identify the correct replacement
orifice spuds using the nameplate burner ratings and the color
code on the replacement spuds as shown in the "Natural Gas
Orifice Spud Chart for Surface Burners."
Replacement Orifice - Natural Gas (High Altitude)
Color Code
White/Red - main
Black - simmer
White/Red
White/Red
White/Brown
White/Brown
White/Orange
A
A. Hex flat
Size Burner Location
1.70 mm Left front
0.52 mm Left front
1.70 mm Left front
1.70 mm Right front
1.20 mm Right rear
1.20 mm Center
1.00 mm Left rear
5