Donning Sequence With Mask/Helmet Combination; During Use; After Use - Dräger HPS 7000 Notice D'utilisation

3.2.10 Changing the position of the eye shield
NOTICE
i i
When the helmet is delivered, the position of the eye
shield is generally correct. The position of the eye
shield is adjustable to accommodate corrective
glasses or distinct facial features. This adjustment
creates more space between face and visor.
1. Remove the eye shield (see chapter 4.3.5 on page 23).
2. Remove the holder from
position 2.
3. Replace the holder
position 1.
4. Attach the eye shield (see
chapter 4.3.5 on page 23).
3.2.11 Attaching the
communication module
z Insert the communication module into the COM holder. It
must snap into place.
3.3 Donning sequence with mask/helmet
combination
1. Adjust the support ring to be wide.
2. Don the fire helmet and push towards neck.
3. Don the full face mask and slip mask/helmet adapter into
the mask pockets.
4. Slide the fire helmet to the correct position. Make sure the
full face mask does not shift.
5. Adjust the support ring to match the head size.
6. Close the chin strap.
7. Check that the full face mask has a secure seal.
Dräger HPS 7000
in
3.4

During use

NOTICE
i i
The helmets of the series Dräger HPS 7000 do not
feature materials known to cause allergic reactions. In
some cases, highly sensitive persons may still
experience reactions.
The visors may transfer physical impacts to corrective
glasses and damage them.
z Move both eye shield levers evenly and carefully when
swinging the eye shield in front of the eyes.
CAUTION
!
Move eye shield levers carefully. Jerky contact of the
eye shield with the nose may lead to injuries.
3.5

After use

Check serviceability as follows:
z
Check helmet shell, internal helmet components, chin strap
and accessory. Replace damaged parts.
01521991.eps
z
Check visors. In case of visible damages or vision
impairments (e. g. scratches, discolouring or dirt), the
visors should be replaced.
z Check painted surface of the fire helmet for damage.
The self-extinguishing special paint system is an important
factor for the thermal performance of the fire helmet. If the
paint is damaged, it may shorten the service life of the
helmet. Superficial paint damage or small surface
scratches do not reduce the protective effect. These can be
repaired with touch up paint.
CAUTION
!
If the fire helmet absorbs the energy of an impact, it
may become damaged or unfit for use. Even if damage
is not immediately visible, the fire helmet must be
01321991.eps
replaced after a severe impact or shock. Damaged
helmets or those exposed to impact may not be used.
This applies even if no external damage is visible.
Fire helmets that may not be reused or repaired are to
be rendered unusable for safety reasons.
Trained personnel or Dräger may check whether the
fire helmet is reusable with damage or should be
repaired.
Use
21