Water Connection; Electrical Connection - Ecolab DG 1-II Notice D'utilisation

5.2

Water connection

 Connect angled valve with its built-in strainer to the wall water supply using a T-union,
if necessary.
 Route the connecting line (suitable type: chromium plated copper pipe, ∅ 10 X 1)
between the angled valve and the water connector at the bottom of the unit.
 Attach the supplied swivel drain outlet to the bottom of the unit.
ATTENTION
Do not load the swivel spout downwards.
5.3

Electrical Connection

The metering unit may only be connected to a supply voltage of 230 V AC with 50/60 Hz.
For the electrical connection of the
complied with.
The integrated power transformer of the
The unit is protected by a fuse which is located on the PCB (630 mA, slow blow) and by a
thermal fuse inside the power transformer.
For the connection to the power supply, the
(length: 2.4 m) with an integrated plug. If necessary, the mains cable can be retracted
into the housing.
If required, the mains cable can be shifted to the left-hand side of the housing
NOTE
(see chapter
417101158_DG1.docx
DG 1-II, all valid national and local regulations must be
DG 1-II
5.4 „Shifting Suction Pipe and Mains Cable to Left-Hand Side of Housing").
36
Fig. 5.1
supplies the entire unit with electric power.
DG 1-II is equipped with a mains cable
Rev. 07-01.16