Installation and Operating Specification EUR EC
8 Controls and Menu
8.1
Multipurpose LC display and keyboard
Actual value display
Display after line voltage is switched on or after
the Esc key combination is used to exit the
A
settings menu (display depends on selected
mode and sensor value).
Main menu
Display after the Esc key combination is used
to exit the actual value display.
B
Select the desired menu group with the ▼▲
buttons and use the P-key to open it.
Program key and open menu.
P
Menu selection, reduce value.
▼
Menu selection, increase value.
▲
Esc-key combination, Escape = leave menu.
▼ + ▲
Switch between Info and Main menu.
Esc
L-BAL-E274-GB 1914 Index 003
1. Status bar
2. Display of the menu group in which the displayed menu is
located
3. Display window
4. Log entry which still was not seen
5. Timer function active
6. Fire-Symbol (heating operation)
7. Moon-Symbol for set point 2
8. Alarm symbol (fault message alternating with actual value
display)
9. Modulation control circuit 1
10. Modulation control circuit 2 (if activated)
11. STOP-Symbol (enable)
12. Position of the menu in the menu group
13. List of the menu groups
Part.-No.
21/117
Controls and Menu