Vulcan GHCB40C Manuel D'installation Et D'utilisation page 6

INSTALLATION CODES AND STANDARDS - ALL BROILER MODELS
Your broiler must be installed in accordance with:
In the United States
1. State and local codes.
2. National Fuel Gas Code, ANSI/Z223.1 (latest edition). Copies may be obtained from The
American Gas Association, Inc., 1515 Wilson Blvd., Arlington, VA 22209.
3. National Electrical Code, ANSI/NFPA-70 (latest edition). Copies may be obtained from The
National Fire Protection Association, Batterymarch Park, Quincy, MA 02269.
In Canada
1. Local codes.
2. CSA B149.1 Natural Gas and Propane Installation Code.
3. CSA C22.1 Canadian Electric Code (latest edition).
The above are available from the Canadian Standard Association, 5060 Spectrum Way, Suite 100,
Mississauga, Ontario, Canada L4W 5N6.
BROILERS MOUNTED ON CASTERS
Broilers mounted on casters must use a flexible connector (not supplied by Vulcan) that complies with
the Standard for Connectors for Movable Gas Appliances, ANSI Z21.69 • CSA 6.16 and a quick-
disconnect device that complies with the Standard for Quick-Disconnect Devices for Use With Gas
Fuel, ANSI-Z21.41 • CSA 6.9. In addition, adequate means must be provided to limit movement of the
appliance without depending on the connector and the quick-disconnect device or its associated piping
to limit appliance movement. Attach the restraining device at the rear of the broiler.
If disconnection of the restraint is necessary, turn off the gas supply before disconnection. Reconnect
this restraint prior to turning the gas supply on and returning the broiler to its installation position.
Separate instructions for installing casters to the broiler are included with the casters.
Note: If the broiler is installed on casters and is moved for any reason, it is recommended that the
broiler be releveled front to back and side to side.
UNSTACKING AND STACKING - MODEL GHCB2
Read all instructions carefully before unstacking or stacking broilers.
The height of Models HCB2 and IR2 sometimes prohibits entry through the kitchen facility doorway.
For this reason, two 3
with each broiler for ease of top section disassembly.
Broilers Shipped Pre-stacked
1. Remove top section finishing back.
2. From oval slots inside finishing back of the top section, remove two 10-24 bolts which connect
the top and bottom sections (Fig. 1).
/ x 1 / x / " (95 mm x 38 mm x 1.2 mm), aluminized stacking straps are shipped
3 1 3
4 2 64
– 6 –