Cleaning And Maintenance; Special Maintenance; Control And Safety Devices - Bartscher LPG4920 Livret D'instructions

2.
LIGHTING BURNERS
•
EN
Open main gas tap upstream of appliance.
•
Push and turn the knob from "closed" position to "maximun flame" and simultaneously press the piezoelec-
tric ignition button a few times until the burner rmains lit.
When first starting up, in order to keep the light ON, keep the knob pressed for about 10 seconds. When it is
released, the light should remain lighted, otherwise, repeat the operation.
•
Turn the knob to the "minimum flame" position to set a slower and more economical cooking procedure, if
required.
SWITCH-OFF
•
To put the appliance out, switch the knob back to position "closed".
•
At the end of the working day, switch off the gas check valve upstream of the appliance.
3.
3.1 Ordinary Maintenance
During the cleaning don't wash the equipment with direct water spout. The cleaning must be executed when the
equipment is cold. Before the cleaning disconnect the equipment. Take away all the oven displaceable elements and
wash them. The stainless steel elements must be washed by hot water and neutral detergent. Rinse the plate by a
soft cloth to remove any trace of detergent. Dry with care. Using abrasive and corrosive detergents you can cause
damages to the stainless steel.
3.2

Special Maintenance

At regular intervals (at least once a year or more often in cases of frequent use), service the appliance thoroughly.
This includes checking the gas circuit, checking parts for damage and if necessary lubricating the taps if they are
difficult to use. Contact a specialised and experienced technician. A maintenance contract should be taken out with
a centre approved by the company.
3.2

Control and safety devices

If the appliance is not used for a long time or if it does not work or works irregularly, the gas stopcock upstream
of the appliance must be shut off.
All the parts of the appliance that are subject to wear can easily be accessed from the front of the appliance after
removing the front.
All the couplings use a dado and bicono, so great care must be taken in handling these components. If the part is
damaged during dismantling or reassembly it must be replaced with a new one.
14
OPERATING INSTRUCTIONS

CLEANING AND MAINTENANCE

Manuale d'installazione e d'uso