Turning Off The Device; Cleaning And Maintenance; Safety Advice - Bartscher IK 235Z Mode D'emploi

•
The power sharing is determined in such a way that both cooking plates operate
simultaneously with an output of 3500 W every time.
•
To be able to set the device at the maximum output, both cooking plates must be
turned on. It is then possible to use the rear cooking plate at an output of 2000 W
and then the front cooking plate output of 5000 W can be used. When the output of
the front cooking plate is set at 5000 W, the rear cooking plate switches
automatically to the power value of 2000 W.
•
For each power setting the value is displayed on the digital display located on the
cooking surface on the left hand side (for the rear cooking plate) and on the right
hand side (for the front cooking plate).
•
If you want to use only the front cooking plate with the 5000 W output, turn the left
hand side knob for the rear cooking plate, one position below the "off" (anti
clockwise).
•
During the device operation ensure that the bottom of the cookware surfaces will not
scratch the cooking surface, even though there is no negative impact on the device's
operation.

Turning off the device

•
After preparing the meal, set both knobs to the OFF position. („0" mark of the knob
positioned at the setting point). Do not rely on the feature of vessel presence
recognition!
•
After turning off the device, the fan runs for approximately 1 minute to cool the device
and protect it from overheating.
NOTE!
If during operation of the device there have been no new settings,
automatically, the device will switch off after 2 hours.

6. Cleaning and maintenance

6.1 Safety advice

o Before cleaning and repairing the device, disconnect it from the power supply
and allow to cool.
o Do not use any acid agents and make sure no water ingresses the device.
o To protect yourself from electric shock, never immerse the device, its cables and the
plug in water or other liquids.
CAUTION!
The device is not suited for direct washing via water jets. Therefore, you must not
use any kind of pressure water jet for cleaning the device!
- 30 -