Cleaning And Maintenance; Safety Advice; Cleaning; Safety Instructions For Maintenance - Bartscher IK 20 Mode D'emploi

6. Cleaning and maintenance

6.1 Safety advice

o Before beginning with repair or cleaning works make sure the device has been
disconnected from power socket (pull the power plug!!!) and has cooled down.
o Do not use any acid agents and make sure no water ingresses the device.
o To protect yourself from electric shock, never immerse the device, its cables and the
plug in water or other liquids.
CAUTION!
The device is not suited for direct washing via water jets. Therefore, you must not
use any kind of pressure water jet for cleaning the device!

6.2 Cleaning

The device should be cleaned regularly.
o
Wipe off the cooking zone with a damp cloth or use a mild, non-abrasive soap
o
solution.
Wipe off the operating panel with a soft cloth or a mild detergent.
o
Use soft cloth only and make sure you NEVER use any kind of abrasive agents or
o
pads, which could scratch the surface.
After the cleaning procedure you should use a soft and dry cloth to wipe dry and
o
polish the surface.
Make sure the device has been cleaned and dried properly for further usage.
o

6.3 Safety instructions for maintenance

o Check the mains connection cable for damage from time to time. Never operate the
device when the cable is damaged. A damaged cable must immediately be replaced
by customer service or a qualified electrician to avoid dangers.
o In case of damage or malfunction, please contact your stockist or our customer
service centre. Pay attention to the troubleshooting tips in pt. 7.
o Only a qualified technician and using original spare parts and accessories should
carry out repairs and maintenance of the device. Do not attempt to repair the
device yourself.
- 30 -