Tone Setup; First Ring Tone; Paging - Topcom BUTLER E600 TWIN Manuel D'utilisateur

Personalize the handset
Turn alarm on/off
Set the alarm time
You can still press any key to turn the alarm off when the keypad is locked.
The alarm volume is the same as the ring volume, when the ring volume is set off,
the alarm will ring at volume 1.
During a call when alarm goes active, you will hear a warning tone through the ear
piece, you can still turn it off by pressing any key.
During paging or ringing, no alarm tone will be hearable.
6.10

Tone setup

When pressing a key, when battery is low or when the handset is out of range you will hear a
warning tone. You can turn this On or Off::
6.11

First ring tone

You can turn of the first ring tone as followed:
6.12

Paging

You can locate a missing handset by pressing the page key
registered to the base will produce the paging tone and "PAGING" is displayed. You can stop the
paging by pressing any key on the handset or by pressing the page-key
28
1 Enter the menu by pressing the left menu key.
2 Select "HS SETTINGS" and confirm.
3 Select "ALARM" and confirm.
4 Select "ON" or "OFF" and confirm.
1 Enter the menu by pressing the left menu key.
2 Select "HS SETTINGS" and confirm.
3 Select "ALARM" and confirm.
4 Select "ON" and confirm.
5 Enter the time (HH-MM) in 24h format and confirm.
6 "SNOOZE" appears and confirm.
7 Select "ON" or "OFF" and confirm.
1 Enter the menu by pressing the left menu key.
2 Select "HS SETTINGS" and confirm.
3 Select "TONE SET UP" and confirm.
4 Select "KEYTONE", "BATTERY TONE" or "OUT FOF RANGE" and
confirm.
5 Select "ON" or "OFF" and confirm.
1 Enter the menu by pressing the left menu key.
2 Select "HS SETTINGS" and confirm.
3 Select "TONE SET UP" and confirm.
4 Select "FIRST RING" and confirm.
5 Select "ON" or "OFF" and confirm.
on the base station. All the handsets
again on the base.