DeWalt DC410 Guide D'utilisation page 14

632249-00,DC410 7/10/06 3:09 PM
CAUTION: If the guard cannot be tightened by the adjusting
clamp, do not use the tool and take the tool and guard to a service
center to repair or replace the guard.
NOTE: Edge grinding and cutting can be performed with Type 27
wheels designed and specified for this purpose; 1/4" thick wheels
are designed for surface grinding while 1/8" wheels are designed
for edge grinding. Cutting can also be performed by using a Type 1
wheel and a Type 1 guard.
FIG. 3
B
LOCKED
OPERATION
Switch (Fig. 3)
LOCK-OFF BUTTON AND TRIGGER SWITCH
Your cut-off tool is equipped with a lock-off button (B).
To lock the trigger switch, press the lock-off button as shown in
Figure 3. When the lock-off button is depressed to the lock icon, the
unit is locked.
Always lock the trigger switch when carrying or storing the tool to
eliminate unintentional starting.
Page 12
UNLOCKED
A
To unlock the trigger switch, press the lock-off button. When the
lock-off button is depressed to the unlock icon, the unit is unlocked.
The lock-off button is colored red to indicate when the switch is in its
unlocked position.
Pull the trigger switch (A) to turn the motor ON. Releasing the trigger
switch turns the motor OFF.
NOTE: This tool has no provision to lock the switch in the ON
position, and should never be locked ON by any other means.
CAUTION: Hold the side handle and body of the tool firmly to
maintain control of the tool at start up and during use and until the
wheel or accessory stops rotating. Make sure the wheel has come
to a complete stop before laying the tool down.
CAUTION: Allow the tool to reach full speed before touching
tool to the work surface. Lift the tool from the work surface before
turning the tool off.
SPINDLE LOCK
The spindle lock pin is provided to prevent the spindle from rotating
when installing or removing wheels. Operate the spindle lock pin
only when the tool is turned off, the battery is removed, and the
wheel has come to a complete stop.
CAUTION: Do not engage the spindle lock while the tool is
operating. Damage to the tool will result and attached accessory
may spin off possibly resulting in injury.
To engage the lock, depress the spindle lock button and rotate the
spindle until you are unable to rotate the spindle further.
Mounting and Using Depressed Center
Grinding Wheels and Sanding Flap Discs
MOUNTING AND REMOVING HUBBED WHEELS
CAUTION: Turn off tool and remove battery before making
any adjustments or removing or installing attachments or
accessories.
12