Care And Maintenance; Main Unit; Filter Cleaning; Dust Sensor,Odor Sensor - Sharp FP-N60CX Manuel D'utilisation

CARE AND MAINTENANCE

To maintain optimum performance of this air purifier, please clean the unit including the
sensors and filters periodically.
When cleaning the unit, be sure to unplug the power cord, and never handle the plug
with wet hands. Electrical shock and/or bodily injury may occur as a result.

MAIN UNIT

To prevent dirt or stains on the
main unit, clean as often as nec-
essary. If stains are allowed to re-
main, they may become hard to
clean.
Wipe with a dry, soft cloth
For stubborn stains or dirt, use a
soft cloth dampened with warm
water.
Do not use volatile fluids
Benzene, paint thinner, polishing
powder, etc., may damage the sur-
face.
Do not use detergents
Detergent ingredients may dam-
age the unit.
Keep the unit away from
water

FILTER CLEANING

Clean the top surface of the Pre-
Filter lightly with a vacuum cleaner.
NOTE
• The True HEPA Filter is damaged
easily. Do not bring it into direct
contact with the nozzle of a
vacuum cleaner or wash it with
water. The True HEPA Filter
should never be washed or
cleaned.
Pre-Filter
All manuals and user guides at all-guides.com
DUST SENSOR
ODOR SENSOR
The maintenance cycle for both the Odor and Dust
sensors is every 3 months.
The sensitivity of the sensors will become unsta-
ble if the odor or dust sensor is dirty or blocked.
Please clean the parts as outlined below.
DUST SENSOR
1
2
3
CAUTION
• Do not forget to reinstall the
sensor cover before restart-
ing the unit.
• Do not insert any foreign
objects into the filter. This
may result in a malfunction
or damage to the unit.
ODOR SENSOR
Remove dust from the surface
of the sensor opening with a
vacuum cleaner.
E-15
Remove the front
panel and detach the
sensor filter
• Remove the sensor fil-
ter while pulling the tab
on the sensor cover.
Remove any dust
from the sensor filter.
• Detach the sensor filter
and tap it lightly with
your hand to remove the
dust.
If it is very dirty, wash it
with water and then al-
low it to dry thoroughly.
Insert the sensor filter
into the cover, install
it in the main unit and
attach the front panel.
• The sensor filter can be
inserted either way
round.
Sensor cover
Sensor filter
Sensor cover
Sensor
opening