Care And Maintenance; Filter Indicator - Sharp UA-HG30E Manuel D'utilisation

CARE AND MAINTENANCE

FILTER INDICATOR

The fi lter Indicator Light will turn
on after approximately 720 hours.
(30 days × 24 hours =720 hours)
This is a reminder to perform the
maintenance described below.
(Ref.E-13,E-14,E-15,E-16)
CARE INDEX
Unit (Ref.E-16)
BACK PANEL
SENSOR
Sensor (internal)
Back Panel
SENSOR
Sensor Filter
In case of using at the location where air pollution and odour are
signifi cant, maintain frequently even if Filter Indicator Light is not ON.
Sensor Filter
HEPA Filter (Ref.E-16)
Deodorizing Filter
(Ref.E-16)
Back Panel
Gently remove dust with an appropriate cleaning tool,
such as a vacuum cleaner with the proper attachment.
NOTE
BACK PANEL
1. Add a small amount of kitchen detergent to
water and soak for about 10 minutes.
CAUTION
• DO NOT apply excessive pressure when
scrubbing the back panel.
2. Rinse off the kitchen detergent with clean water.
3. Completely dry the fi lter in a well-ventilated area.
After performing
maintenance, reset
the Filter Indicator.
How to clean when overly dirty
1. Remove the Back Panel and removing
the Sensor Filter.
2. Gently remove dust from the Sensor with
an appropriate cleaning tool, such as a
vacuum cleaner with the proper attachment.
3. If the Sensor Filter is overly dirty, wash it
with water and dry it thoroughly.
E-13
Press more than
3 seconds.
Humidifying Filter
Filter Frame
Humidifying Tray
(Ref.E-14,E-15)