Warm Tech PAP24000 Mode D'emploi page 92

After the temperature in the stove is lower than 30degree, finally, the phrase
'GOODBYE' is displayed.
!! ATTENTION !!
During the flame switching off phase and exchanger cooling, it isn't possible to switch on again the
heater up to the operation end; this state is highlighted from the message 'SWITCHING OFF'
At the switching on the flame isn't started immediately, depends from the selected functioning
formality. Two formalities are settable: AUTOMATIC or MANUAL, for further details see the
appropriate section.
The switching on Stage, which has the duration of about 15-20 minutes, are necessary to the
resistance to carry the pellets at the switching on temperature, (depends from the heater). The
switching on procedure is showed from a passages set showed in the display. Before starting the
switching on, the heater performs the brazier cleaning and displays the following wording:
Firstly,
Secondly,
Thirdly,