Operation - Warm Tech PAP24000 Mode D'emploi

5. Operation

ALL NATIONAL AND LOCAL REGULATIONS AND EUROPEAN STANDARDS SHALL BE
COMPLIED WITH WHEN OPERATING THE APPLIANCE
1.) The first ignition
When first time's running, the paint can be get rid of by burning. So some unpleasant Smell might
come out. Please open the window and door to vent the smell.
Note: If the new stove, when its first time using, it is necessary to put a handful of wood pellet to the
fire pot before hand.
Put wood pellet fuel into the hopper, connect the power. Then On/Off Light is Lighting (It means that
power is on). Operate as the instruction on section 2"start and operation"
2. )Start and operation
Please operate the stove as following (refer to stove structure figure and electrical control figure):
Check the box, pellet grate bar，ash pan then adjust to proper position.
Switching on / switching off
The heater switching on and switching off is performed through the ON/OFF key
At the switching on the message, CLEANING will be shown on first,
Cleaning' is displayed for 20 second, in order to clean the fire pot.
In the same way, push , then at the switching off Period, the message shows: