Cleaning The Flue Gas Passage Ways - Warm Tech PAP24000 Mode D'emploi

ASH DRAWER REMOVAL AND CLEANING
Caution: Do not remove the ash drawer when the stove is hot. Pull the ash drawer forward and away
from the stove.
Caution:
Disposal of Ashes should be placed in a metal container with a tight fitting lid. The closed container
should be placed on a noncombustible floor or the ground well away from all combustible materials,
pending final disposal. If the ashes are disposed of by burial in soil or otherwise locally dispersed, they
should be retained in the closed container until all cinders have been thoroughly cooled. Reinstall the
ash drawer by inserting the drawer in the stove and refastening the left and right latches securely.
Note that if the ash drawer does not seal tightly to the stove, the control board may detect a leak and
shut the stove down.
CLEANING THE COMBUSTION BLOWER
To clean the combustion blower, remove the four nuts labeled. A in the drawing to the right with an
11/32''wrench.After removing these nuts, the motor with fan attached can be pulled from the fan
housing. The fan blades and the fan housing can be vacuumed once the motor is removed.
When reinstalling the motor, a new gasket may need to be installed between the motor and the fan
housing. To complete the reinstallation, place the motor back on the fan housing and reinstall the six
nuts. Make sure the motor's green ground wire is secured under one of the nuts.

CLEANING THE FLUE GAS PASSAGE WAYS

Cleaning the flue passageways should be done at least once a year. Burning high ash pellets may
require this cleaning to be done more often. Clean these passageways only when the stove and ash
are cold do not start a fire in the vacuum cleaner by vacuuming up hot ash. On each side of the stove
there are two access covers (see B and C on the drawing to the right) that can be removed by
unscrewing the two 5/32'' allen head screws. Insert a cleaning brush in the openings to loosen any
ash buildup and use a vacuum cleaner to remove the loosed ash. Reinstall the covers when cleaning
is complete. There are also two more access holes located behind the ash drawer.