Starting And Use Of The Machine - Dalla Corte Evolution Notice Pour L'utilisateur

Starting and use of the machine

Follow all the instructions de-
scribed below with the help of
the picture.
• Open the water tap (1 Pic.1).
• Turn on the electrical switch (4
Pic.1) and turn the knob clockwi-
se; make sure that the led10 is on.
• Once the machine is on, the
automatic level starts the filling
up of the boiler until the proper
level.
At this stage, the led10 is on.
• Right after that, verify that led8
is on too (heating of the boiler).
NOTE
This coffee machine was conceived in order to save a good quan-
tity of energy, therefore during the heating up of the machine,
the coffee groups only heat up when the boiler has reached the
correct temperature. If you want to use the groups before the
boiler has finished heating, switch the machine off and on again,
pressing at the same time the cups-warmer button, (or about
10 seconds), the heating of the groups then begins, led3 and 6
lighten, while led8 is off. In order to go back to the heating up of
the boiler, press the cups-warmer button for at least 10 seconds
until led8 turns on.
26
• During the boiler heating stage,
the brewing groups 9 are not fun-
ctioning and do not get warm, but
it is possible to reserve the tur-
ning on of the brewing groups you
want to use by pressing button P7
for 10 sec., this will be confirmed
by led3 and led6 blinking.
• When the boiler reaches the
correct temperature, brewing
groups will start heating up.
When all brewing groups re-
quested to heat up reach the
temperature, the unit will emit
a "beep" sound, confirming that
it is ready to be used.