Alarms - Dalla Corte Evolution Notice Pour L'utilisateur

Alarms

As well as recording the pro-
gramming of all the above de-
scribed functions, the electronic
board of this espresso machines
also controls their proper exe-
cution.
The incorrect execution of any
of these functions triggers an
alarm, showed on the display
as below:
LOSS OF MEMORY DATA
LED's of all buttons P6 turn on
and machine gives out 3 beeps.
To cancel the alarm, turn the
main switch of machine off and
back on. This alarm could be
triggered due to strong spikes
in the power supply. In case of
memory loss, machine will ope-
rate with factory (default) para-
meters.
TRANSFORMER
Total machine lockup, LED's 8
and 9 turn on and machine gives
out a continuous beep. To cancel
the alarm turn the main switch
of the machine off and back on.
This alarm is triggered when the
electronic board senses the lack
of load from the safety transfor-
mer, therefore all solenoid val-
ves stop operating.
AUTO-FILL SYSTEM
Boiler lockup, LED # 7 blinks
and machine gives out 3 beeps.
To cancel the alarm turn the
main switch of the machine off
and back on. This alarm is trig-
gered when the electronic board
senses that the auto-fill probe
contact remains open beyond
the time-out time (programmed
in the SET menu).
SAFETY LEVEL
Boiler lockup. LED # 7 blinks,
LED # 8 turns off and machi-
ne gives out 3 beeps. To cancel
the alarm turn the main switch
of the machine off and back on.
This alarm is triggered when the
electronic board senses that the
safety probe (short probe) con-
tact remains open for over 30
seconds.
TEMPERATURE PROBE BOILER
Boiler lockup, LED # 8 blinks
and machine gives out 3 beeps.
To cancel the alarm turn the
main switch of the machine off
and back on. This alarm is trig-
gered when the electronic board
senses that the readings of the
temperature probe boiler are
out of range.
33