NSK PRESTO AQUA LUX Mode D'emploi page 6

<Removal>
Holding the Water Supply Bottle, press the Bottle
Attaching/Detaching release button until it is locked, keep
pressing Attaching/Detaching release button while holding
the Control Unit and pull Water Supply Bottle upwards.
( Fig.7 )
CAUTION
After use, if water is low in the Water Supply
Bottle, the Water Supply Bottle may pop out
while pressing the release button; therefore you
must make sure the Water Supply Bottle is held
securely when pressing the release button.
(6) Installation and Removal of the Water Supply Bottle Cap
<Installation>
Check the seal inside the Water Supply Bottle Cap for misalignment or detachment before clsoing the Water Supply Bottle
Cap. ( Fig.8 )
<Removal>
Before opening the Water Supply Bottle Cap, be sure to press the Bleeder Button to release the pressure in the Water
Supply Bottle. (Fig. 9) Check that the pressure is completely released before opening the Water Supply Bottle Cap.
( 7 ) Installation and Removal of Water Filter Set ( Use of Main Water )
Push the hose of the water filter set ( the end with the
water filter ) into the tap water connector on the back of
the Control Unit until it is securely held in place as shown
in Fig. 10. Check if the hose is securely held in place by
slightly tugging it after connection. Connect the other end
of the hose to the tap water line.
CAUTION
To disconnect push the white ring on the water connector towards the control unit and gently pull the tube out of
the connector.
Water Bottle Water Bottle
Packing Packing
Water Supply Water Supply
Bottle Cap Bottle Cap
Fig. 8
5
3
1
Bleeder Button Bleeder Button
Water Connector Water Connector
White Ring White Ring
Hose Hose
Water Filter Case Water Filter Case
2
Fig. 7
Fig. 9
Fig. 10