NSK PRESTO AQUA LUX Mode D'emploi page 5

( 3 ) Installation of Foot Control
Loosen and remove the Hose Stoppers ( two ) from the
Foot Control Connectors on the back of the Control Unit,
and insert them into Foot Control Connector the Foot
Control hoses. At this time, insert the Hose Stoppers so
that their screws come outside ( Control Unit Side ) .
Insert the "1"-marked end of each hose according to the
instructions on the label. After insertion of both hoses,
securely tighten the hose stoppers. ( Fig.3 )
( 4 ) Installation of Handpiece
Connect the Handpiece Hose to the Handpiece Connector on the front of the Control Unit ( Fig.3 ) . Attach the handpiece to the
Coupling Hose by pulling back the sleeve of the Coupling Hose insert the handpiece and release the sleeve. ( Fig.5 )
Handpiece Connector
Coupling Hose
( 5 ) Installation and Removal of Water Supply Bottle
<Installation>
Press the Bottle Attaching/Detaching release button on
the back of the Control Unit until it engages and is locked.
( Fig. 6 ) Insert the Water Supply Bottle from above and
push downwards until the Bottle Attaching/Detaching
release button returns to its original position. Check to see
if the water supply bottle is securely held in place pull it
upwards.
CAUTION
Check to see if the Bottle Attaching/Detaching release button has returned to its original position and the Water
Supply Bottle is securely held in place. If it is not securely held in place water and air may leak, and the Water
Supply Bottle may pop out.
Fig. 4
Water Supply Water Supply
Bottle Bottle
4
Foot Control Connector Foot Control Connector
Hose Stopper Hose Stopper
Coupling Hose
2
Bottle Attaching/Detaching Bottle Attaching/Detaching
release button release button
1
Fig. 3
Fig. 5
Fig. 6