NSK PRESTO AQUA LUX Mode D'emploi page 4

2. Specifications
Control Unit
Model
LED Power Range
Control Unit Dimensions
Power Supply
Air Volume
Water Pressure
Water Volume
Water Tempter
3. Installation Procedures for Each Part
( 1 ) Installation Procedures for Each Part
Push the plumbing hose into the Plumbing Connector
located at the regulator on the left-hand side of the
Control Unit. Connect Plumbing Hose and Control Unit as
shown in Fig.1. Check if the hose is securely installed by
slightly tugging it after connection. Connect the other end
of the plumbing hose to the air line. At this time, use the
attached connector if necessary.
CAUTION
• Push the plumbing hose into the connector until it is securely set. Otherwise, air may leak.
• Pushing the white ring, on the plumbing connector, gently remove the tube.
( 2 ) Installation of AC Power Supply
Insert the AC Adaptor into Power connector firmly.
NE272
3.5Vdc 0.7A
W235XD139XH182 ( mm )
5Vdc
30 ~ 40 L/min
(0.25 ~ 0.3 MPa)
0.1 ~ 0.3 MPa
0 ~ 45L/min
0 ~ 40 ˚C
Handpiece
Speed
Proper Air Supply Pressure
Handpiece Dimensions
AC Adaptor
Model
AST018T-W050V
Input 100 - 240Vac 50 - 60Hz 0.48A
Output
5Vdc 3A
White Ring
Plumbring Connector
Plumbring Hose
Power Connector Power Connector
AC Adaptor AC Adaptor
3
-1
320.000min
0.25~0.3MPa
ø16.6 X104 ( H ) mm
Fig.1
Fig.2