Language; Factory Setting; Software Version - TechniSat DIGITRADIO UP 1 Mode D'emploi

[Standby] regulates the brightness in standby mode. You can choose from
the [High], [Middle], [Low] brightness intensities and [Off]. Using the << or
>> buttons, select a brightness intensity and press the Enter button to save.
If the [Off] option is selected, the display lighting will be switched off
completely on standby after approx. 10 seconds.

11.3 Language

> Keep the Info/Menu button depressed and use the << or >> buttons to select
the [Language] item.
> Press the Enter button.
> Using the << or >> buttons, select one of the available languages and confirm
by pressing the Enter button.

11.4 Factory setting

If you change the location of the device, e.g. when moving house, it is possible that
the saved stations can no longer be received. In this case you can reset the device to
factory settings to delete all the saved stations and then launch a new scan.
> Keep the Info/Menu button depressed and use the << or >> buttons to select
the [Factory Setting] item. Press the Enter button.
> Using the << or >> buttons, select the [Yes] item to reset to the factory setting
and press the Enter button.
All previously stored stations and settings will now be deleted. The device is
now in the same status as when delivered.
> [Restart...] appears on the display and the device initiates. Following this, the
device automatically performs a complete scan in DAB mode. While scanning,
the display information shows the progress, as well as the number of digital
radio stations detected. After completing the station scan the first DAB+
channel is played.

11.5 Software version

Under SW version you can retrieve the currently installed software version.
> Keep the Info/Menu button depressed and use the << or >> buttons to select
the [SW Version] item.
> Press the Enter button. The current software version is displayed.
EN
FR
IT
NL
NW
DK
PL
CZ
SK
25