Other Functions; Sleep Timer; Alarm; Setting The Alarm Time - TechniSat DIGITRADIO UP 1 Mode D'emploi

10 Other functions

10.1 Sleep timer

You can activate the sleep timer if you want the DIGITRADIO UP1 to switch to standby
automatically after a specific time.
> Keep the Info/Menu button depressed and use the << or >> buttons to select
the [Sleep] item.
> Using the << or >> buttons, you can set the period as intervals of Off, 15, 30,
45, 60 and 90 minutes, after which the device is switched to standby from
any operating mode.
> After selecting a time interval press the Enter button.
In the top left corner of the display, a clock symbol appears to indicate that the sleep
timer is active.
If you retrieve the Sleep timer menu again, the remaining running time is
shown.

10.2 Alarm

> Keep the Info/Menu button depressed and use the << or >> buttons to select
the [Alarm] item.

10.2.1 Setting the alarm time

The wake-up function cannot be operated until the correct time has been
set. Depending on the configuration, this occurs automatically or must be
set manually. The time can either be updated manually or via DAB/FM. See
Section 11.1 for further information.
> Select an alarm time memory (alarm 1 or alarm 2) using the << or >> buttons
and confirm with Enter.
> Go through all the points one after the other. Confirm each entry with the
Enter button:
[Alarm Time] > Set the time you wish to be woken at using the << or >>
buttons and press Enter.
[Duration] > set the duration of the alarm using the << or >> buttons and
press Enter.
[Source] > Select the wake-up tone (buzzer or radio source) using the << or
>> buttons and press Enter.
If you have selected digital radio (DAB) or FM as the wake-up tone source, you
can then select a station from the station list or the last selected channel as
the playback source. Then press Enter.
EN
FR
IT
NL
NW
DK
PL
CZ
SK
21