GE UPSE810 Manuel D'utilisation page 8

STANDARD REAR EXHAUST
(Vented above floor level)
ELBOW HIGHLY
RECOMMENDED
NOTE: ELBOWS WILL PREVENT DUCT KINKING
AND COLLAPSING.
LEVELING AND STABILIZING
5
YOUR DRYER
STAND THE DRYER UPRIGHT NEAR THE FINAL LOCATION AND
ADJUST THE 4 LEVELING LEGS, AT THE CORNERS, TO ENSURE THAT
THE DRYER IS LEVEL FROM SIDE TO SIDE AND FRONT TO REAR.
LEVEL
FRONT-TO-BACK.
4 LEVELING
LEGS
ELBOW HIGHLY
RECOMMENDED
RECOMMENDED
CONFIGURATION
TO MINIMIZE
EXHAUST
BLOCKAGE.
LEVEL
SIDE-TO-SIDE.
USING FLEXIBLE METAL DUCTS
If rigid all-metal duct cannot be used, then flexible all-metal
ducting can be used, but it will reduce the maximum
recommended duct length. In special installations when it
is impossible to use only metal ducting, then UL-listed
clothes dryer flexible metal transition duct may be used as
transition venting between the dryer and wall connection
only. The use of this ducting will affect dry time.
If flexible transition duct is necessary, the following
directions must be followed.
• Use the Shortest Length Possible.
• Stretch the Duct to Its Maximum Length to avoid kinks.
• Do Not Crush or Collapse the Duct.
• Never Use Transition Duct Inside the Wall or Inside
the Dryer.
• Avoid Resting the Duct on Sharp Objects.
• Venting Must Conform to Local Building Codes.
ELBOW HIGHLY
RECOMMENDED
ELBOWS HIGHLY
RECOMMENDED
DO NOT USE
EXCESSIVE
EXHAUST
LENGTH
8
DO
DONT
DO NOT
SIT DRYER
ON FLEXIBLE
EXHAUST.
DO NOT
CRUSH
FLEXIBLE
EXHAUST
AGAINST
WALL.