Loading And Using The Dryer; Fabric Care Labels - GE UPSE810 Manuel D'utilisation

About loading and using the dryer.
Always follow the fabric manufacturer's care label when laundering.
Sorting and Loading Hints
As a general rule, if clothes are sorted properly for
the washer, they are sorted properly for the dryer.
Do not add fabric softener sheets once the load has
become warm. They may cause fabric softener stains.
Bounce ® Fabric Conditioner Dryer Sheets have been
approved for use in all GE Dryers when used in
accordance with the manufacturer's instructions.
Care and Cleaning of the Dryer
The Exterior: Wipe or dust any spills or washing
compounds with a damp cloth. Dryer control panel
and finishes may be damaged by some laundry
pretreatment soil and stain remover products. Apply
these products away from the dryer. The fabric may
then be washed and dried normally. Damage to your
dryer caused by these products is not covered by
your warranty.
The Lint Filter: Clean the lint filter before each use.
Moisten your fingers and reach into the filter opening.
Run your fingers across the filter. Have a qualified
technician vacuum the lint from the dryer once a year.

Fabric Care Labels

Below are fabric care label "symbols" that affect the clothing you will be laundering.
WASH LABELS
Machine
wash
cycle
Water
temperature
BLEACH LABELS
Bleach
symbols
Hand wash
Normal Permanent Press/ Gentle/
wrinkle resistant delicate
Hot Warm Cold/cool
(50°C/120°F) (40°C/105°F) (30°C/85°F)
Any bleach Do not bleach
Only non-chlorine bleach
(when needed)
(when needed)
Do not overload. This wastes energy and causes
wrinkling.
Do not dry the following items: fiberglass items,
woolens, rubber-coated items, plastics, items with
plastic trim and foam-filled items.
Stainless Steel: To clean stainless steel surfaces, use
a damp cloth with a mild, non-abrasive cleaner
suitable for stainless steel surfaces. Remove the
cleaner residue, and then dry with a clean cloth.
The Exhaust Duct: Inspect and clean the exhaust
ducting at least once a year to prevent clogging. A
partially clogged exhaust can lengthen the drying
time.
Follow these steps:
Turn off electrical supply by disconnecting the
1
plug from the wall socket.
Disconnect the duct from the dryer.
2
Vacuum the duct with the hose attachment and
3
reconnect the duct.
The Exhaust Hood: Check from the outside that the
flaps of the hood move freely when operating. Make
sure that there is not wildlife (birds, insects, etc.)
nesting inside the duct or hood.
DRY LABELS
Tumble
dry
Do not wash Do not wring
Heat
setting
Special
instructions
24
www.GEAppliances.ca
Dry Normal Permanent Press/ Gentle/ Do not tumble dry
wrinkle resistant delicate
High Medium Low No heat/air
Line dry/ Drip dry Dry flat
hang to dry
Do not dry
(used with
do not wash)
In the shade