Dryer Features; The Dryer; Using The Drying Rack - GE Profile PTDS850GMWW Manuel De L'utilisateur Et Instructions D'installation

Dryer Features.

Screw
Water
Water
ONLY
tank
Duct Sensing
The duct blockage system automatically
monitors, detects and alerts you to
blockages in the ductwork. Blocked
ductwork can degrade dryer performance by
reducing airflow from the dryer. If you
observe the display window with the
message, "CLg" it is time to clean your
exhaust ducting in order to increase
Changing the Drum lamp
Before replacing the drum lamp, be sure to
unplug the dryer power cord or disconnect
the dryer at the household distribution panel
by removing the fuse or switching off the
circuit breaker.

using the Drying Rack

A handy drying rack may be used for drying
delicate items such as washable sweaters.
Hook the rack over the lint filter so the rack
extends into the dryer drum.
using the Steam Cycles
Add Water
Before using a Steam Cycle, the water tank
must be filled with water up to the MAX line.
If not, the ADD WATER light will blink. Make
sure that the water tank is filled with water
and the cartridge is completely connected.
Turn the dryer off and then restart the Steam
Cycle.
1. Turn the dryer off by pressing the POWER
button.
2. Open the lid.
3. Move the lever to open.
4. Lift out the water tank and open the tank
lid.
5. Fill the tank to the MAX water line with
water.
6. Place the water tank back into the barrel
and move the lever to close.
7. Close the lid, press the POWER button and
select the cycles desired.
efficiency and reduce dry times.
The drum lamp is located at the top left of
the door frame.
1 Remove the screw holding the drum lamp
shield in place.
2 Slide the shield up and remove.
3 Remove the bulb and replace with a
15-watt, 120-volt candelabra-base bulb.
4 Replace the lamp shield and screw.
NOTE:
• The drying rack should only be used with
the TIME DRy cycle. It is also strongly
recommended when drying sneakers.
• Do not use this drying rack when there
are other clothes in the dryer.
NOTES
• Only use water. Do not fill the water tank
with foreign substances, rinse agents, or
detergents.
• Before moving the dryer, make sure the
water tank is empty.
• Do not use distilled water; the water level
sensor in the steam generator will not work.
• Be careful while filling the water tank to
avoid overflow and spilling.
• Wipe up any spilled water around the water
tank and the drawer before starting the
dryer.
GEAppliances.com
11