GE Profile PTDS850GMWW Manuel De L'utilisateur Et Instructions D'installation page 25

USING FLEXIBLE METAL DUCT FOR
TRANSITION VENTING
Rigid or semi-rigid metal ducting is
recommended for use as transition ducting
between the dryer and the wall. In special
installations when it is impossible to make a
connection with the above recommendations,
then a UL-listed flexible metal transition duct may
be used between the dryer and wall connection
only. The use of this ducting will affect dry time.
If flexible metal transition duct is necessary,
the following directions must be followed:
• Use the shortest length possible.
• Stretch the duct to its maximum length.
• Do not crush or collapse.
• Never use flexible metal ducting inside the wall
or inside the dryer.
• Avoid resting the duct on sharp objects.
• Venting must conform to local building codes.
FOR TRANSITION VENTING
(DRYER TO WALL), DO:
Installation Instructions
•DO cut duct
as short as
possible and
install straight
into wall.
•DO use elbows
when turns are
necessary.
Elbows
DO NOT:
25
•DO NOT bend or
collapse ducting.
Use elbows if
turns are
necessary.
•DO NOT use
excessive
exhaust length.
Cut duct as short
as possible.
•DO NOT crush
duct against
the wall.
•DO NOT set
dryer on duct.