Reversing The Door Swing - GE Profile PTDS850GMWW Manuel De L'utilisateur Et Instructions D'installation

REVERSING THE DOOR SWING (if desired)
Hole cap
STEP 1
Open the door and remove the two plastic hole caps on
the catch side by gently prying up with a flat blade
screwdriver. Save these for step 6.
CAuTION:
Support the weight of the door when
removing the screws in the next step. Failure to properly
support the weight of the door could result in property
damage, damage to the dryer, or personal injury.
STEP-2 REMOVE HANDLE
Remove the screws holding the handle and two
spacers.
Hinge Screw
STEP 3
While supporting the door, remove the 4 screws, two from
each hinge. Set the door aside face down on a protected
surface to prevent damage to the door or the work
surface.
Installation Instructions
32
inner door frame
STEP 4
With the door on a protected surface, remove the 12
screws on each side of the door and lift off the inner door
frame using a flat blade screwdriver. Remove the latch
hook and blank and move them to the opposite side.
STEP 5
Remove the 4 screws securing the hinges to the door
frame. Remove the two plastic cover caps. Reinstall the
hinges and cover caps on the opposite sides from which
they were removed.
STEP 6 REVERSE HANDLE
Install the handle on the opposite side of
the door.
latch hook
Hinge
assembly
Cover cap