Reversing The Door - GE GTMS855EDMC Mode D'emploi

About reversing the door.

Reversing the Door

Tools needed:
n Standard #2 Phillips screwdriver
n Tape-tipped putty knife
n Small flat blade screwdriver
Before you Start
Unplug the dryer from its electrical outlet .
1
Open the door approximately 170 degrees . With a putty
knife, remove the 4 plastic covers located along the left
side of the front panel and set them aside .
Plastic Cover (4)
2
Remove the bottom screw from each hinge (right side)
and partially insert them into the top left side hinge
holes .
NOTE: All 4 front panel hinge screws will now be in the top
hinge holes - 2 on the left and 2 on the right .
12
Left side of
front panel
3
Loosen the bottom 2 right side hinge screws . Remove the
door and place it on a protected flat surface to avoid any
damage . Remove both the Blind Plate and the Strike
Plate and install them in opposite positions .
Blind plate
Inner door
4
Remove the 4 door hinge screws, 4 edge screws, and 8
inside screws . Lift the inner door upwards using a flat
blade screwdriver .
Inside screws
Door hinge
screws
Strike plate
Inner door
Inside screws
Outer door
Edge
screws