GE GTMS855EDMC Mode D'emploi page 7

Temperature
E
High
Medium
Low
Extra Low
No Heat
Options
F
Delay Dry
As the Delay Dry button is repeatedly pressed, the delay time sets to from 1 to 9 hours, and back to clear (0) . After selecting
the delay time, press Start and the delay time will count down the time remaining until the cycle starts .
If the Delay Dry button is pressed for 3 seconds, it clears (regardless of the delay time) or terminates a delaying cycle .
Extended Tumble
Use this option to minimize the wrinkles in clothes . It provides 1 hour of no-heat tumbling after the clothes are dry . If you are
using the cycle Signal and you select the Extended Tumble option, a signal will sound at the end of the drying time and every
5 minutes during the Extended Tumble cycle . This will remind you that it is time to remove the clothes .
Damp Alert
This option causes the dryer to beep when clothes have dried to a damp level . Remove items that you wish to hang dry . The
Damp Alert will only beep when this option is selected (but the dry cycle will keep running) . Removing clothes and hanging them
when they are damp, can reduce the need to iron some items . The light beside the button will be lit when Damp Alert is on .
Rack Dry
Rack Dry is only allowed for timed cycles (Timed Dry & Quick Fluff) . The light turns off if cycle knob is turned to a non-timed cycle .
My Settings
G
As the cycle selector knob is turned, the Time (Timed Dry), Level (Dryness Level), and Temp (Temperature) settings change to
automatic pre-set default settings . If you desire a different setting, press the appropriate button(s) . Then press and hold the
My Settings button for 3 seconds . The status heart and button lights will turn on and the dryer will save these settings for that knob
selection . In the future, when you turn the selector knob to that cycle, your settings will be automatically recalled .
To temporarily (for this load) return to the pre-set default settings, depress the My Settings button for 1/2 second . The status heart
and button lights will turn off and the options will change back to these defaults . To make these default settings permanent, hold the
My Settings button again for 3 seconds to make them your preferred settings (the lights will turn back on) .
NOTE: Variable Signal volume cannot be set for My Settings .
Variable Signal
Use the Variable Signal button to change the volume of the end of cycle and control signals . Press the button until you reach
the desired volume (low-med-high) or off . The clothes should be removed when the beeper goes off so wrinkles do not set in .
NOTE:
• Remove garments promptly at the sound of signal . Place clothes on hangers so wrinkles will not set in .
• Use the Variable Signal especially when drying fabrics like polyester, knits and permanent press . These fabrics should be
removed so wrinkles will not set in .
Drum Light
The drum light will go on if the Drum Light button is pushed or the door is opened . It will stay on until the door is shut or the
Drum Light or Power button is pushed .
Control Lock
You can lock the controls to prevent any selections from being made . Or you can lock the controls after you have started a
cycle . Children cannot accidentally start the dryer by touching buttons with this option selected .
To lock the dryer controls, press and hold the Control Lock button for 3 seconds . The control lock icon will light up when locked .
To unlock the dryer controls, press and hold the Control Lock button for 3 seconds .
NOTE: The Power button can still be used when the machine is locked.
eDry
H
Available for Bulky Items, Towels/Sheets, Cottons, Normal/Mixed Loads, Jeans, Casuals/Permanent Press, Active Wear,
and Delicates . When the eDry button is pressed, cycle settings change to reduce the total energy consumption of the
selected sensor cycle . NOTE: Cycle times will change when eDry is selected.
The eMonitor lights display the relative energy use of your selected cycle and options . They are provided as an energy guide
and range from Good (1 light) to Better (5 lights) . Cycle (time), dryness level, temperature, and additional tumble options can
increase or decrease your energy efficiency . Some special cycles will not provide a display .
For regular to heavy cottons .
NOTE: Steam Dewrinkle and Steam Refresh require the High temperature setting .
For synthetics, blends, delicates and items labeled permanent press .
For delicates, synthetics and items labeled tumble dry low .
For delicates, synthetics and items labeled tumble dry low .
For fluffing items without heat . For use only with the Timed Dry cycles .
GEAppliances.com
7